Also, your vehicle takes a specific type of brake fluid; typically (but not always), DOT3 or DOT4. In newer vehicles, it will often say right on the brake fluid reservoir cap. If not, consult your vehicle’s owner’s manual. CAUTION: DO NOT USE BRAKE FLUID OTHER THAN THE SPECIFIC TYPE RECOMMENDED FOR YOUR VEHICLE.
Can you use any brake fluid any car?
Check your vehicle’s owner’s manual to see if there are any specific instructions for the type of brake fluid you should use. Also, the cap usually states what kind of brake fluid is required. For the vast majority of vehicles, a standard glycol-based DOT 3 or DOT 4 brake fluid should be used.
How do I know what type of brake fluid I need?
The best way identify what type of brake fluid your car needs is to check your owner’s manual. You can also check the master cylinder reservoir cap to identify the type of brake fluid used in your vehicle.
Is brake fluid the same for all cars?
Myth #6: The same type of brake fluid can be used in all types of vehicles. Different vehicles with different types of brakes require different types of fluid. Our technicians will ensure the correct type of fluid is put in your vehicle, per the manufacturer’s specifications.
Can I use any DOT 4 brake fluid in my car?
DOT 3 and DOT 4 brake fluids are interchangeable for the most part. DOT 4 has a slightly higher boiling point. 230C for the DOT 4 vs 205C for the DOT 3. Unless you have a high performance car and like to overwork the brakes, you will likely not have a need for the higher boiling point DOT 4.
What happens if you mix different brake fluid?
Since DOT 4 and 5.1 are both glycol-based brake fluids they are compatible with each other, which means they can be readily mixed without harming your brake system. … By mixing DOT 3, 4 and 5.1 brake fluids, assuming it is fresh fluid, the worst thing that can happen is a drop in the boiling point of the whole fluid.
Can I just add brake fluid to my car?
If your brake fluid is at or above the “MIN” line, your brake fluid level is fine and you don’t need to add any. If your fluid is below the “MIN” line, carefully pry the reservoir cap off, and then add brake fluid until the level is just under the “MAX” line. Do not overfill.