Can you remove car dents with boiling water?

Not quite! Here’s a few reason why this is risky to try: You have a high risk of burning your fingers before you are able to successfully pop the dent back into place. Using boiling water on the car part is just as likely to cause further damage, which will only increase the cost of repair.

Will boiling water damage my car paint?

The heat makes the metal more expandable and malleable, allowing it to be pushed and pulled easily. … Pouring hot water over metal also has its problems. It could warp the metal out of shape, make it less sturdy; it could even ruin your paint job if your paint isn’t up to par.

Does boiling water get dents out of metal?

Before applying tools, try the following: wash the dented surface with hot, possibly boiling water. With a bit of luck the metal will flex and pop back in its original form. This also works on plastic bumpers. The hot water always supplies sufficient heat to make the paint and the material smooth.

IT IS INTERESTING:  In what circumstances should a driver use the vehicle side lights?

What happens if you pour boiling water on your car?

If you use boiling water on a very cold day, the glass could even shatter, leaving you with a very pricey repair bill – and all for the sake of a few minutes. Damaged paintwork – Pour scalding hot water on the windscreen, and you run the risk of damaging the paintwork as the water runs off.

How do you pop a dent out of hot water?

Use hot water for dented bumpers

Heat water to boiling in a pot or big tea kettle and pour it over the dent. Wearing gloves to protect your hands, quickly reach behind the bumper and push out the dent. If you can’t get behind the bumper easily, remove it from the car for the procedure.

How do you get minor dents out of your car?

The quickest and often easiest dent removal method is to use a sink or cup plunger, which will work on small to medium sized dents (depending on the plunger size). Wet the plunger and the dent, place the plunger over the damaged area and begin pushing and pulling.

How do you get a dent out of a metal bumper with hot water?

Fill a pot with water and bring it to a rolling boil. Carefully pour the water over the surface of the dent to heat up the metal. Allow the metal to flex and return to its original shape. If the bumper is plastic, push the dent out from behind after you pour the hot water over it.

IT IS INTERESTING:  Your question: Should I get a transmission flush or change?

Does hot water and a plunger dent removal?

Pour the hot water over the dented surface of the car. This softens the material. Put the plunger over the indented area and pull straight out. Your dent should pop right out.

Can small dents be popped out?

Not only can you unclog a drain with a plunger, but you can also get out small- to medium-sized dents out of your car too. Just splash some water on both the plunger and the dent and start pushing and pulling until it pops out. Make sure to use a cup plunger (for sinks), not a flange one (for toilets).

How do body shops remove dents?

To ensure that doesn’t happen, body shops use a process called “paintless dent removal” (PDR). PDR requires no fillers or sanding, as a trained technician uses a variety of special tools to gently and slowly push dents back into place without harming the factory paint job.