Can I use rubber hose for transmission cooler lines?

You can use rubber hose, but make sure it’s transmission cooler line rated. The pressure is quite low (12-15 psi). Double clamp it or use FI type clamps instead of the worm-drive style.

What kind of hose can I use for transmission fluid?

Due to the chemical properties of PTFE hose it’s a perfect fit for using braided lines for your transmission fluid lines.

Can fuel hose be used for transmission cooling lines?

Fuel Line Hoses. … So you can probably use power steering hose in a transmission oil cooler application, but not vice versa, at least not in a pressure line application.

Are transmission cooler lines high pressure?

Its NOT only pressure you have to worry about, its also compatibility with the trans fluid. NOT aware of the pressures being any higher than other transmissions, so if you use “Transmission Cooler Hose” you should be fine.

What fluid runs through transmission cooler lines?

How Car Transmission Lines Work. Car transmission lines connect your vehicle’s transmission to the vehicle’s radiator. Also known as transmission cooling lines, they are typically made of metal or composite aluminium and rubber hoses because they can handle the flow of hot transmission fluid.

IT IS INTERESTING:  Can you put electrical tape on a car battery terminal?

Does it matter which transmission cooler line goes where?

The top hose from the transmission cooler goes to the top pass through nipple to the transmission and the bottom hose from the transmission cooler goes to the bottom pass through nipple into the bottom of the radiator.

How do transmission cooler lines connect to radiator?

Transmission coolers do not attach to the radiator. They attach in-line with the transmission fluid return line. It is common for an OEM transmission cooler to be built into the radiator tank to be cooled by the coolant in the radiator.

Can you use heater hose for PCV?

4 Answers. Yes, you could use any fuel and oil resistant hose. They are typically made of silicone, polyurethane or rubber.

Can rubber fuel line be used for oil?

Fuel line is a petroleum-resistant nitrile tube with a covering that resists weathering, ozone and heat and can be used for ethanol-laced fuels and diesel fuel. It should, however, not be used on coolant systems, oil systems or fuel-injection systems that produce pressures higher than 50 psi.

How do you stop a transmission line from leaking?

If you discover a leak from a gasket or seal in your transmission, the best way to stop the leak is to simply add BlueDevil Transmission Sealer to your transmission fluid.

How much pressure is there in a transmission line?

During normal operation, its about 150 and the return line around 50 psi.

Why do transmission cooler lines leak?

Transmission cooling lines leaking means either low-level of fluid or interrupted flow in the transmission. In both cases, the result is an overheated transmission that may stop functioning if the condition persists. Sometimes, it is difficult to spot the leak at the initial stage.

IT IS INTERESTING:  Can you dye car seats?

What can causes low line pressure in a transmission?

Line pressure is normally effected by throttle position and the gear range. … Pressure that are lower than specifications are usually caused by leaking seals or a worn oil pump. Higher than normal pressures are usually caused by a faulty pressure regulator.