Fuel line hose isn’t up to the pressures normally associated with automatic transmissions. Use the proper stuff. If that thing splits or blows loose and hoses down any portion of your exhaust system hot enough to ignite it, your truck could end up burned to the ground.
Is fuel hose OK for transmission fluid?
Fuel line will work for oil or atf. They also say if it is high pressure on the hose”fuel injection”. Just dont use vacuum hose. You will be fine with high pressure fuel line, but do not use the low pressure stuff.
What kind of hose can I use for transmission fluid?
Due to the chemical properties of PTFE hose it’s a perfect fit for using braided lines for your transmission fluid lines.
How much pressure is on a transmission line?
During normal operation, its about 150 and the return line around 50 psi.
Can you repair transmission lines?
These lines pull transmission fluid from the transmission and take it to the radiator, where it cools down. … If they break or develop a leak, you will lose transmission fluid, leaving your car vulnerable. Thankfully this is a fairly simple fix, and most transmission line repairs cost between $100 and $500 dollars.
What are transmission lines used for?
The lines that carry radio waves from the radio transmitter to the antenna are known as transmission lines; their purpose is to convey radio-frequency energy with minimum heating and radiation loss. Heating losses are reduced by conductors of adequate size.
How do you stop a transmission line from leaking?
If you discover a leak from a gasket or seal in your transmission, the best way to stop the leak is to simply add BlueDevil Transmission Sealer to your transmission fluid.
What line is the return line on a transmission?
The lower line near the bottom will be the return line.
Why do transmission lines go to radiator?
Car transmission lines connect your vehicle’s transmission to the vehicle’s radiator. … Your car’s transmission lines are essential to preventing the transmission from overheating by carrying hot fluid away from the transmission until it is cooled and subsequently pumped back into the transmission.
Does it matter which transmission line goes where?
Generally the higher line on the radiator has fluid going INTO the transmission and the lower one goes back to the transmission, so the higher line has fluid coming out of it and the lower line sucks it back into the transmission.
Can you use rubber hose for transmission cooler lines?
You can use rubber hose, but make sure it’s transmission cooler line rated. The pressure is quite low (12-15 psi). Double clamp it or use FI type clamps instead of the worm-drive style.
What can causes low line pressure in a transmission?
Line pressure is normally effected by throttle position and the gear range. … Pressure that are lower than specifications are usually caused by leaking seals or a worn oil pump. Higher than normal pressures are usually caused by a faulty pressure regulator.
Is transmission cooler high pressure?
Its NOT only pressure you have to worry about, its also compatibility with the trans fluid. NOT aware of the pressures being any higher than other transmissions, so if you use “Transmission Cooler Hose” you should be fine.
How long does it take to fix a transmission line?
Transmission repair can take a full day but it will take at least 3 to 4 days to rebuild a transmission.
What happens when your transmission line breaks?
When your transmission goes out, your car’s handling will be affected. You may experience vibrations, slippage (engine revs but vehicle does not accelerate as it should) or different shift patterns in your vehicle. The gear shift on your car will stop working when the transmission dies.